.gif) |
| Yarramalong Turf
Supplies |
|
|
Step 1 - Soil
Preparation |
|
|
|
Clear weeds
from the area to be turfed. This can be done by using a
non-selective herbicide, such as glyphosate. Ideally weeds
should be cleared 7-10 days before turfing.
|
|
|
 |
|
|
If the area requires
excavation, this should be done next.
Adequate
drainage is essential for a successful lawn. Rotary hoe, or
cover area with good quality top soil: If clay based, apply
gypsum prior to covering with top soil or rotary
hoeing.
Rake area to a fine smooth
finish.
|
|
|
Step 2 - Measuring and
Ordering |
|
|
 |
|
|
With a tape,
measure the area to be turfed. Measure length and width
in metres and multiply the two measurements. Also include any
odd shapes or unusual features to the nearest possible
measurement.
|
|
|
|
This should result in the
total amount of turf required in square metres. For
assistance with measurement, don't hesitate to contact us! It may
interest you that one roll of cut turf measures 2.5 m long with a
width of 0.40m (1 square metre).
Turf is a living plant, and
for best results should be delivered on the day planned for
laying. Turf should be laid immediately upon delivery.
Begin
watering lawn within 30 minutes of installation, especially
in summer. Turf requires ground contact and moisture to
survive.
|
|
|
Step 3 - Laying your new
lawn |
|
|
|
Begin by laying your new
lawn around the outside of the area to be turfed,
against pathways, garden edges, etc. forming a border. Then
continue by laying across any slopes you may have, trimming
excess turf at the border along the outside, with a knife or
spade.
|
|
|
 |
|
|
Turf should be laid in a
brick pattern for a neater finish. Butt and push ends against
each other tightly, without stretching. Avoid leaving gaps or
overlapping. Note: on a large lawn it is best to complete small
sections by rolling turf as you go, so watering your new lawn can
commence.
Give your new lawn at least 25mm of water within
30 minutes of installation. Water daily (depending on weather
conditions), keeping turf moist, until it is firmly rooted. Be sure
your new lawn has enough moisture to survive hot, dry or windy
periods.
Check turf by carefully lifting in areas, and
checking for moisture and new roots. Once turf cannot be lifted,
waterings can be spaced to once or twice a day ( depending on
weather conditions). Caution: avoid heavy or concentrated use of
your new lawn in the first few weeks after laying, allowing the
roots to firmly knit with the soil. A bump free, firmly rooted
surface will result.
To have your questions answered please
email
us. |
|
|
